Page 1 of 1

Connector End A and B - accessing the property

PostPosted: Fri Mar 27, 2020 4:19 pm
by heidi.j.jugovic@saic.com
When I build a table based on connectors, I can see in the column selection properties that distinguish between End A and End B. Also, in the specification of the connector, the end properties are defined in two separate sections, one labeled Connector End A and one labeled Connector End B. However, when I go to the ends as they are owned under the connector, I can see no properties in the specification window of a given end/role that indicates if it is end A or end B.

I would like to create a table that lists end A in one column and end B in another column, but I cannot seem to identify the property using the usual trick of looking in the specification window. I know the property must exist somewhere, but how can I expose/access it for the purpose of metachain or model operations?

Thanks,
Heidi

Re: Connector End A and B - accessing the property

PostPosted: Wed Feb 03, 2021 12:54 pm
by mike.martines@gmail.com
Did you ever figure this out?

Re: Connector End A and B - accessing the property

PostPosted: Wed Feb 03, 2021 1:00 pm
by heidi.j.jugovic@saic.com
I did not