Page 1 of 1

Par Diagram Error:"Input/output is not specified for [par]"

PostPosted: Tue Oct 10, 2017 8:54 am
by NSpringmeyer@apogeeintegration.com
When I attempt the launch the MBSE Analyzer plugin and select my parametric diagram, or run a simulation of my par diagram using the simulation toolkit, I get the following errors:

MBSE Analyzer: "Input/output is not specified for [parameter]. Make it sure 'direction' tag is set properly."
Simulation Toolkit: "Unable to determine path for block..."

Where can I properly set these direction tags and/or paths, depending on whether these messaged are caused by the same issue?

Re: Par Diagram Error:"Input/output is not specified for [par]"

PostPosted: Tue Oct 10, 2017 10:54 pm
by jirawat.l@nomagic.com
Hello,

Could you please tell us about some information?

We need to know that the message of Simulation toolkit show in simulation console or notification window for investigation.
And what version of your MagicDraw and Cameo Simulation Toolkit plugin ?

Best Regards,
No Magic Customer Support