Page 1 of 1

Activity Parameter Multiplicity

PostPosted: Wed Jul 27, 2022 3:59 pm
I am trying to get an action to run multiple times by giving it multiple object on a object flow.

I have set the multiplicity on an input pin into action X to be 5. It has an incoming object flow from another action (Y). The output pin on action Y has a multiplicity of 10. Whenever the simulation runs it fails to get past action Y, but if I change the multiplicity on action x to 1 it works just fine. As far as I can tell an input pin cannot have a multiplicity greater than 1 or the simulation will fail.

My expectation is that action x should run twice since I gave it 10 objects and it needs 5 to perform an execution. Is this not supported with simulation toolkit?