Page 1 of 1

Default Tags

PostPosted: Tue Sep 28, 2021 8:44 am
by sean.densford@raytheon.com
I have a profile that gives specific enumeration literals for Table stereotype and defaults are set, but when I use them on a diagram the defaults are not populated. Is there a way to specify that default values are initialized for a value upon use? I know it works for signals, but I can't find an analog for Stereotypes.

Re: Default Tags

PostPosted: Tue Sep 28, 2021 1:30 pm
by sean.densford@raytheon.com
The resolution is to set the multiplicity to 1 on the tag definition. This makes it required and therefore uses the default.